Fish Feed Mixer Machine

Next > >

<< Previous

Send Inquiry

Product Code : 06

Product Description

Fish feed mixing machine is critical equipment in Fish Feed Plant, our offered Fish Feed Mixture is a single-shaft and double-ribbon mixer that is also known as a ribbon blender. It is widely used for mixing powdery feed materials to ensure a high quality compound feed. This fish feed mixture is a well performed mixer for fish and other livestock feed production plants.

Highlights and Advantages

Multi-use: It can be used for food additives, feed, binder, silicone rubber, pigment, printing ink, resin, paraffin, vanishing cream, ointment, detergent, etc and also can be used for mixing viscous fluid and thick, sticky and granular materials.
Multi-working-pattern: Mixing model is scraper type, inner-spin type and outer-ribbon type
Flexible design: According to the requirement of our clients or with different feed formulas, this mixer can be equipped with a jacket for heating and cooling materials. If required, thermal insulation materials can also be installed.
It has a large loading coefficient and small coverage area. It is a good choice for plants with larger output demand and no need for changing raw materials frequently.

How does it work?

Speed reducer drives the agitating shaft
Spiral ribbon makes materials move up and down
Central spiral pushes the materials in the middle to both ends
Outer spiral ribbon presses the material from both ends to the middle that helps central discharging
At the same time, the outer spiral lifts the material along with the inner wall of the mixer, leading to a circulation of materials in the mixer and provides an even mixing result

Reasonable Operation

After starting this feed ribbon blender, check the running direction, rotating on the opposite direction is not allowed
The processing volume should not be more than dischargeable capacity
After 15 days of the first operation, discharge the lubricant and clean the oil tank. Changing the lube in the speed reducer every 3 months is recommended. Lubricating the grease on the bearing every 2 months is required or is adjustable according to the working condition.
Light repair of the machine is needed after 1800-hour running for checking the lubrication points and replacing the quick-wear parts. Heavy repair is needed after 4000-hour of running then disassembles to check and clean all the components, replace quick-wear parts and adjust standard units.